Replace Tv Station Positions; Manual Tv Station Presetting - Pioneer DVR-RT501-S Operating Instructions Manual

Various settings

Replace TV station positions

You can replace the channel positions as you like.
Example: Replace the TV station No. 6 with position
No. 2.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
moving channel position number (6) and press
ENTER.
CH
SKIP
MOVE
3
Select "MOVE" and press ENTER.
CH
SKIP
MOVE
4
Select the channel position number (2) to which
the selected position at step 2 above is to be
moved and press ENTER. Now these channel
positions were replaced with each other.

Manual TV station presetting

The Automatic station presetting function (See page
28) memorises the available broadcasts to suitable
CH positions.
Some broadcasts may not be preset correctly by the
automatic tuning system - in this case you can tune
stations manually as follows.
Example: Presetting a station on program position 5.
1
Select "CH TUNING" and press ENTER.
2
Select "CH" and press ENTER. Then select the
channel position number (5) and press ENTER.
CH
SKIP
MOVE
3
Select "TUNING" (tuning scale) and press
ENTER.
CH
SKIP
MOVE
TUNING
2H30301B_En_18_29
6
OFF
6
6
OFF
6
5
OFF
5
5
OFF
5
29
4
Press A (rising frequency) or B (falling
frequency) once. The search starts. It stops at
each broadcast automatically. ("A" changes to
" ") Press B or A repeatedly until the desired
station appears. If the broadcast is too weak
(eg. with a drifting picture), the search will not
stop. If you want to stop, press C/D or B/A.
CH 5
SKIP OFF
MOVE 5
TUNING
SEARCH F. TUNE
ENTER ENTER RETURN BACK
5
If the tuned-up picture is not satisfactory, press C
or D until the best picture is achieved. Then
press ENTER.
6
Repeat the steps 2 and 5 to preset other TV
stations.
NOTE:
Occasionally, the auto search might catch a weak
signal and stop. If the TV station signal is weak, you
shouldn't store this station. In that case restart the
auto search using B or A.
8/4/05, 19:21
02
SETUP END
29
En