Table of Contents
Advertisement
Getting started
Making your first recording
This quick guide shows you how to make a basic
recording of a TV program to a recordable DVD.
Recording is covered in much more detail in chapter 6
(Recording).
STANDBY/ON
STOP
REC
STOP REC
ì
DVD RECORDER
1
If they aren't already on, switch on your TV and
this recorder.
Press
STANDBY/ON to switch on.
• Make sure that the video input on your TV is set to this
recorder.
2
Press
OPEN/CLOSE to open the disc tray.
3
Load a blank DVD-R or DVD-RW disc with the
label side face-up, using the disc guide to align the
disc.
• When you load a new, blank DVD-RW disc, the
recorder will take a moment to initialize it for
recording.
OPEN/CLOSE
CHANNEL
PLAY
4
Use the CHANNEL +/– buttons to select the TV
channel you want to record from.
• You can also use the +/– buttons on the front panel if
the recorder is stopped.
• Antenna channels are numbered 2 through 69. Cable
channels are numbered 1 through 125.
Press ì REC to start recording.
5
• By default, the recording will be in SP (standard play)
mode, which will give you around two hours of
recording from a blank DVD disc.
• You can pause recording by pressing
Press ì REC or
PAUSE again to restart recording.
6
When you want to stop recording, press
STOP REC.
Playing back your recording
The TV program you just recorded should be on the DVD
disc as a single title with one or more chapters.
•
Press
PLAY to start playback.
If you want to stop playback before the end of the
STOP.
recording, press
Using the built-in TV tuner
Changing TV channels
There are three different ways to select TV channels. Note
that you can't change the TV channel during playback,
recording or during recording standby.
• CHANNEL +/– buttons on the remote
• Number buttons on the remote – For example, to
select channel 4, press 4 then ENTER; for channel 34,
press 3, 4, ENTER; for channel 102, press 1, 0, 2,
ENTER.
• +/– buttons on the front panel
PAUSE.
CHANNEL
ENTER
04
27
En
Advertisement
Table of Contents
