I/O Buttons; Volume Controls - Extron electronics DTP CrossPoint 4K Series User Manual

I/O Buttons

NOTE: See
of the following operations.
Primary functions
Secondary functions
Control insert
configuration
Resets
Video button (see
H
button has one primary function (❏) and two secondary function (•):
❏ Selects and deselects video for a configuration that is being created or viewed and
lights green to indicate that video is available for configuring or for viewing.
With the Audio button, indicates Control Insert Configuration mode.
•
With the Audio button, commands the front panel system reset.
•
Audio button (see
I
function (❏) and two secondary functions (•):
❏ Selects and deselects audio for a configuration that is being created or viewed and
lights to indicate that audio is available for configuration or viewing.
With the Video button, indicates Control Insert Configuration mode.
•
With the Video button, commands the front panel system reset.
•

Volume Controls

NOTE: The following volume functions are in the default group masters configuration.
Operation of these controls can be changed using the DSP Configurator software (see
Group masters
If you change the group master configuration, the front panel controls adjust the new
group masters that you create.
Mic Volume (gain) knob and LEDs (see
J
page 26) — Rotate the knob clockwise to increase the pre-mixer gain for all four
microphone inputs. By default, this knob controls DSP group master 2.
Volume knob and LEDs (see
K
to increase the output 1 amplified volume. By default, this knob controls DSP group
master 1.
For both volume controls, the range is from -100 dB to +12 dB. The default setting
is 0 dB. As the volume increases or decreases, the LED bar ramps up and down to
indicate the current volume range, as shown in the
The sensitivity of the encoder (the amount [dB] of volume adjustment per step of
rotation) varies depending on the current volume setting (see the last column in the
table).
Front Panel Operations, beginning on page 34, for detailed descriptions
Action Select video
Indication Green: selected
VIDEO
Indication Blink: Control Insert Configuration Mode.
Action: Perform a system reset.
figure 24
on page 25 and
figure 24 and figure
on page 119).
figure 24
DTP CrossPoint 4K Series Matrix Switchers • Operation
Select audio
Red: selected
AUDIO
figure 25
on page 26) — The Video
25) — The Audio button has one primary
figure 24 on page 25 and
and figure 25) — Rotate the knob clockwise
table on the next page.
figure 25 on
32