GB
SERVICE MANUAL
STEERING AND BRAKING SYSTEM
BRAKE ASSEMBLY REMOVAL
1.
Drive the machine on a level ground.
2.
Turn the ignition key (10) to OFF position.
3.
By means of a proper lifting system, hook the machine at the front anchorages (33) and lift it 30 cm from the
ground. Then securely fix it in this position.
4.
Remove the nut (A) and the front wheel (B).
5.
Disengage the brake lever (D) lead-in wire (C); if necessary loosen the register (G).
6.
Remove the four screws (E) and the brake assembly (F).
7.
Disassemble the brake lever (D), then install it on the new brake assembly (F), in the same position as the
old brake assembly.
8.
Install in the reverse order of removal.
9.
Carry out the Brake adjustment as described on the previous page.
100
Figure 3
G
D
E
F
C
A
B
S300123
S30N1100(1)2002-01