Battery Operation - Honeywell SPM Flex User Manual

SPM Flex Gas Detector
• Load a Chemcassette cartridge
• Configure the detector and begin to monitor (see pages 15-16 for basic display
usage)
• See detailed Operation (pages 32-41) and Optional accessories (pages 53-55)
Additional accessories
• External dust filters (required on inlet)
• Tubing
• Sampling wand
• Mating signal connectors for fixed installations
The ports of a typical installation is shown in the figure below�
Sample in port
Ethernet
connector
Figure 1. terminals and ports

Battery operation

The SPM Flex gas detector is supplied with a power supply/charger than can
connect the detector's power connection and a standard wall outlet� (Ensure that
the correct power cable has been ordered for local operation�) The power supply/
charger is designed for indoor, dry-location use only� The lithium-ion battery pack
provides continuous operation of 6+ hours, depending on sampling conditions
and unit configuration� The battery's charge time is typically 4 hours� The
detector can be operated while its battery is being charged (this may increase
the charge time)� Because batteries discharge slowly when not in use, Honeywell
Analytics recommends keeping the detector connected to the power supply/
charger when not in use�
WARNING
!
• The battery is not field-replaceable� Return the unit to Honeywell Analytics if
a battery replacement is necessary�
• Risk of fire and burns� Do not open, crush, heat above 140ºF (60ºC), or
incinerate the battery� Follow manufacturer's instructions�
10
Exhaust out port
Power connector
Relays or 4-20 mA connector