Honeywell SPM Flex User Manual page 16

SPM Flex Gas Detector
The display
Figure 6 shows the elements of the display that will be seen in various situations�
Alarm 1/
Alarm 2/
Inhibit
Mute
indicator
Status bar
15: 42: 01
123
0
.
H2S - Hydrogen Sulfide
In monitor
Gas name
Gas concentration
Monitor mode indicator
Figure 6. Elements of typical SPM Flex detector displays
The bar graph on the right shows the current concentration relative to the Alarm
1 and Alarm 2 setpoints� (The bar's range is relative to the alarm levels, not to the
full scale of the selected gas)�
The color of the status bar changes according to the system status (green = OK/
in monitor, yellow = fault, red = alarm, blue = Out of Monitor mode)�
Display and navigation
Under normal operation the LCD and LED display system status, gas
concentrations, and alarms� In set-up, review, calibration, and test modes, the
LCD shows the relevant menu options and system status bar� The interface is
navigated using the four buttons:
Control
Up arrow Scroll up through lists of options
Down arrow Scroll down through lists of options
Accept/Select Accept or select a highlighted option
Power/Cancel will turn the unit on if it's in the off state, will exit back to the previous menu level, and will
Power/Cancel
enter Reset mode (quick press), or Power Off mode (long press and hold) from the main display.
In the main display mode, the display shows the current gas name and
concentration, the monitoring states and faults and/or alarm status, if applicable�
16
Instrument
Concentration
Fault
trend
Maintenance
indicator
Fault
Menu
title
2
Menu
options
ppm
5.678
1.234
Bar graph
Units
w/upper, lower
alarm limits
Function
Monitor
mode
Indicator
Battery
Clock
indicator
15: 42: 01
Main menu
Login / Logout
Reset alarms/faults
Monitor mode
Change Chemcassette
Highlighted
option
Scroll bar