Honeywell SPM Flex User Manual page 37

Network
The Network Summary option displays the IP address, the Subnet mask, the
Gateway, and the MAC address�
Additional Status
The flow rate of the gas, the battery level, the ambient temperature and relative
humidity, and the stream temperature and relative humidity can be found on the
Additional Status Summary screen�
Output State
The detector's relay assignment (i�e�, Alarm 1, Alarm 2, or Instrument Fault), the
current relay states (e�g�, off, off, on), the current mA output (driven value and
measured value), and the current inhibit state are displayed in the Output State
Summary�
Trend/Plot
The Trend/Plot review screen shows the date, time, and time range� A trend plot
over the specified time range can be displayed� The data can be exported to a
flash drive via the USB port as a csv file�
Software
The Software summary screen displays the number of the current version
numbers of the software, the user interface, the gas detection algorithm, the
optics algorithm, and the RFID algorithm�
WARNING
!
Calibration, set-up, and test modes are intended for use by trained personnel
or service engineers only� Access to these modes can be passcode protected�
Maintenance menu
Inhibit
Alarms or alarms and faults can be inhibited from the Maintenance menu� The
timeout period (the length of time before inhibit mode is exited and monitoring
resumes) can also be configured here� The range is 1 to 60 minutes� The default
timeout period is 30 minutes� A timeout period of 0 minutes means that the
feature is disabled�
4-20 mA current loop calibration
This feature allows the detector's output to match an external monitoring device�
Flow characterization
Flow characterization is an optional function� When utilized, it allows a flow
system to be optimized with a certain type of Chemcassette cartridge� This
allows the SPM Flex detector to quickly reach the correct flow rate�
SPM Flex Gas Detector
37