Optimum Battery Operation; Replacing The Battery; Replacing A Sensor Or Sensor Filter - Honeywell GasAlert Max XT II User Manual

GasAlertMaxXT II
User Manual
4. Allow the battery to charge for 6 hours. The charging
indicator flashes (low, mid, and full charge repeatedly) on
the LCD while the battery is charging.
5. When charging is complete, the charging indicator stops
flashing and displays
Remove the adapter and activate the detector.
If the battery indicator does not display, refer to
Troubleshooting.
To preserve the life of the battery, deactivate the detector when
not in use.
The detector may be warm immediately after charging. This is
normal.

Optimum Battery Operation

To ensure maximum use of the battery, perform the following:
• To obtain full operating capacity, allow the battery to fully charge
and discharge three times.
• To achieve the maximum number of charges, ensure the battery is
charged between 32°F and 113°F (0°C and 45°C). Do not charge
the battery in temperatures above 113°F (45°C).
54
low mid full
to indicate a full charge.
Note

Replacing the Battery

To replace the lithium battery, refer to
ries to order the (XT-BAT-K1) kit that includes the Replacing the
GasAlertMaxXT Battery Operator's Manual.

Replacing a Sensor or Sensor Filter

To avoid personal injury and/or property damage, use
only sensors that are specifically designed for the
detector. Refer to Replacement Parts and
• Each sensor has a high degree of resistance to common
vapors and gases. To clear a sensor, move the detector to a
clean environment and wait 10 to 30 minutes.
• Do not expose a sensor to vapors from inorganic solvents
such as fumes from paint thinners, or organic solvents such as
benzoic acids and acrylic acids).
To replace a sensor or sensor filter, refer to
• Table 11.,
• Figure 9.,
• Figure 10., and
• the following procedures.
Replacement Parts and Accesso-
a Warning
Accessories.