Symbols Used In This Guide - Extron electronics DA2 HD 4K User Manual

Symbols Used in this Guide

When programming in the field, certain characters are most conveniently represented by their
hexadecimal rather than their ASCII values. The table below shows the hexadecimal equivalent
of each ASCII character:
Space
Table 1.
]
or
|
• —
W or
The
Response Table.
X!
X@
X#
X$
X%
X^
X&
X*
X(
ASCII to HEX Conversion Table
ASCII to HEX Conversion Table
— Carriage return with line feed
} — Pipe character or carriage return (no line feed) can be used interchangeably.
space character
E — W or Escape key can be used interchangably.
X/ values defined in this section are the variables used in the fields of the Command
— Output
through , DA2 HD 4K
1 2
1 through 4 , DA4 HD 4K
through , DA6 HD 4K
1 6
— Status
= disabled, off, or undetected
0
= enabled, on, or detected
1
— Video color bit depth (default =
= auto (based on EDID of sink)
0
1 = force 8-bit
— EDID memory location (default =
table
(see on page 15)
— EDID data as 256 bytes of Hex data (text representation)
— Native resolution and refresh rate (translated from Hex)
for example:
1600x1200 @ 60 Hz
— Controller firmware version to the second decimal place
— Text string of up to 24 characters (default =
Alphanumeric characters and hyphens only.
No distinction between upper and lower case.
No spaces.
First character must be a letter and the last character cannot be a hyphen.
— Output HDCP mode (default =
= Encrypt as required by input.
0
Continuous trials for HDMI sinks
Attempt for 10 seconds on DVI sinks and then fail.
1 = Always encrypt.
Continuous trials for HDMI sinks.
Attempt for 10 seconds on DVI sinks and then fail.
2 = Encrypt as required by input. Continuous trials for HDMI and DVI sinks.
3 = Always encrypt. Continuous trials for HDMI and DVI sinks.
.
)
0
)
39
DA-HD-4K-SERIES
)
0
DA HD 4K Series • SIS Commands
).
19