Sun Microsystems Sun Fire V20z Management Manual page 71

Subcommands in Appendix A
TABLE A-1
Subcommand
sp set jnet
sp get locatelight
sp set locatelight
sp add mount
sp delete mount
sp get mount
sp get port 80
sp add snmp-destination
sp delete
snmp-destination
sp get snmp-destinations
sp get snmp proxy
community
sp set snmp proxy
community
sp get tdulog
sp update flash all
Note – Every command returns a return code upon completion.
Description
Sets the JNET address.
Reads the value of the locatelight switch (which represents
the state of the front and rear panel identification lights).
Sets the state of the locatelight switch.
Creates or resets a mountpoint.
Deletes the specified mountpoint.
Displays the current mountpoints on the SP.
Retrieves the last port 80 postcode from the PRS Port80
register.
Adds an SNMP destination.
Deletes the SNMP destination.
Displays the available SNMP destinations (IP address or
host name) to which the SP is configured to send.
Returns the community name currently being used by the
SP SNMPD to proxy the platform SNMP agent.
Sets the proxy entries that specify the OID to be referred,
the IP address to which they are referred, and the
community string to use while proxying.
Captures debug-dump data and stores it on the SP in
compressed format.
Sets the update flag to start the full flash update on the
next SP reset.
Appendix A Commands 59