Attaching The Front Brackets - Brocade Communications Systems 5300 Hardware Installation Manual

Installing the 1U and 2U Fixed-Mount Rack Kit for Four-Post Racks (XBR-R000162)

Attaching the front brackets

CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device, as shown in the following figure.
2. Insert two 8-32 x 5/16-in. screws into one of the pairs of vertically aligned holes in the bracket and then into the pair of holes
on the side of the device. To install the device in a recessed position in the rack, use the bracket holes that are set back from the
end of the bracket.
3. Insert additional 8-32 x 5/16-in. screws through the holes in the bracket and into the corresponding holes in the device. The
number of screws may vary depending on the device model.
4. Repeat step 1 through step 3 to attach the left front bracket to the left side of the device.
5. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
FIGURE 10 Attaching the front brackets
1. Bracket, front right
32
2. Screw, 8-32 x 5/16-in., panhead Phillips
Brocade 5300 Hardware Installation Guide
53-1000858-07