Attaching The Rear Brackets To Front Brackets - Brocade Communications Systems 5300 Hardware Installation Manual

Installing the 1U and 2U Non-Port Side Fixed-Mount Rack Kit (24") for Four-Post Racks (XNA-000073 and XNA-100073)
3. Attach the left front bracket to the left front rack upright using two 10-32 x 5/8-in. screws and two nuts as shown in the
following figure.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 33 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips (2)
2. Retainer nuts, 10-32 (2)

Attaching the rear brackets to front brackets

Complete the following steps to attach the rear brackets to the front brackets.
1. Position the right rear bracket inside the right front bracket.
2. Attach the brackets using four (4) 6-32 x 1/4-in. screws as shown in the following figure.
3. Adjust the brackets to the rack depth and tighten the 6-32 x 1/4-in. screws to a torque of 9 in-lbs. (10 cm-kgs).
4. Repeat step 1 through step 3 to attach the left rear bracket to the left front bracket.
FIGURE 34 Attaching the rear brackets to the front brackets
1. Bracket, front right
2. Screws, 6-32 x 1/4-in., flathead Phillips (4)
56
3. Bracket, front right
3. Bracket, rear right
Brocade 5300 Hardware Installation Guide
53-1000858-07