Attaching The Rear Brackets To The Rack Posts - Brocade Communications Systems 5300 Hardware Installation Manual

Attaching the rear brackets to the rack posts

Complete the following steps to attach the rear brackets to the rack posts.
1. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. screws and two retainer nuts as shown in the
following figure.
2. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. screws and two retainer nuts.
3. Tighten the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 35 Attaching the rear brackets to the rack posts
1. Bracket, front right
2. Retainer nuts, 10-32 (2)
Brocade 5300 Hardware Installation Guide
53-1000858-07
Installing the 1U and 2U Non-Port Side Fixed-Mount Rack Kit (24") for Four-Post Racks (XNA-000073 and XNA-100073)
3. Bracket, short rear right
4. Screws, 10-32 x 5/8-in., panhead Phillips (2)
57