Fan Assemblies - Brocade Communications Systems 5300 Hardware Installation Manual

Brocade 5300 Maintenance
Use one of the following methods to determine if you need to replace a power supply.
• Check the power supply status LED next to the On/Off switch (see
• In Web Tools, click the Power Status icon.
• Enter the psShow command at the prompt to display power supply status as shown below:
br5300:admin> psshow
Power Supply #1 is OK
V10529, TQ2H0000030
Power Supply #2 is OK
V10541, TQ2H0000189
br5300:admin>
For further information on replacing the power supplies, see the Mid-Size Switch Power Supply Replacement Procedure .

Fan assemblies

The three fan assemblies are hot-swappable. They are identical and fit into any fan assembly slot.
Each fan assembly contains two fans, identified by Fabric OS as follows (viewing the switch from the non-port side):
• Fan assembly #1 on the right
• Fan assembly #2 in the center
• Fan assembly #3 on the left
Use one of the following methods to determine if you need to replace a fan assembly.
• Check the fan status LED on the face of the fan assembly (see
• In Web Tools, click the Fan Status icon.
• Enter the fanShow command at the prompt:
br5300:admin> fanshow
Fan 1 is Ok, speed is 4821 RPM
Fan 2 is Ok, speed is 4821 RPM
Fan 3 is Ok, speed is 4891 RPM
br5300:admin>
For further information on replacing the fan assemblies, see the Brocade 5300 Fan Assembly Replacement Procedure .
72
,60-0300031-01,X2,
,60-0300031-01,X3,
LED locations on page 65)
,SP640 ,2X,TQ2H0000
,SP640-2P ,A ,TQ2H0000
LED locations on page 65)
Brocade 5300 Hardware Installation Guide
53-1000858-07