Brocade Communications Systems 5300 Hardware Installation Manual page 40

Slide Rack Mount Kit (XBR-R000070)
3. Press the lock-release lever located inside the inner slide rail and pull the inner rail away from the outer rail.
4. Repeat these steps for the second slide assembly.
NOTE
The device must be turned off and disconnected from the fabric during the installation
procedure.
FIGURE 18 Pulling the slide rails apart
1. Inner slide rail
2. Lock-release lever
Attaching the inner slide rails to the device
Perform the following steps to attach the inner slide rails to the device.
1. Position an inner slide rail with the flat side against the device and the end containing the lock-release lever toward the non-port
side of the device.
2. Align the rail holes with the holes drilled in the side of the device, as shown in the following figure.
NOTE
The hole pattern is identical for all 1U, 1.5U, and 2U devices.
3. Attach the rail using three Phillips 8-32 x 3/16-in. screws.
4. Tighten the screws to a torque of 15 in-lbs (17 cm-kgs).
40
3. Slide assembly
Brocade 5300 Hardware Installation Guide
53-1000858-07