Digital Watchdog DWC-PB6M4T User Manual page 32

Webviewer - Settings
Events
Digital Input
1
Logical Status (Sensor Type)
Set according to the normal state of the electrical signal of
the attached device. (Open / Close)
1) N.O. (Normal Open) : in case of the normal state is "open"
2) N.C. (Normal Close) : in case of the normal state is "close"
2
Click OK to apply any changes to the settings.
[Event Types]
3
Digital Input
When the Digital Input (DI) is detected, an event occurs,
The detection status can be adjusted in detail as below.
1) active to inactive : when the detected state of the DI is
changed into the non detected state, and event occurs.
2) inactive to active : when the non detected state of the DI
is changed into the detected state, and event occurs.
3) active level : when the detected state of the DI maintains,
the event maintains.
4) inactive level : when the non detected state of the DI
maintains, the event maintains.
4
Motion
When the motion is detected, an event occurs.
5
Timer
The events occurs periodically. (unit : second)
[Action Types]
6
Preset Move
When the PTZ Camera is connected to, the command
"Preset Move" is sent to the PTZ camera.
7
Digital Output
This means "relay output". The signal "Digital Output" is
sent by the time that is defined. The output status can be
adjusted as below.
1) close to open : sends the signal "Digital Output" to
"open" state.
2) open to close : sends the signal "Digital Output" to
"close" state.
8
TDN
This means "True Day & Night". Available only to some IP
camera models. The color can be adjusted as below.
1) BW : Sets the color to "Black and White".
2) Color : Sets the color to "Color".