Digital Watchdog DWC-PB6M4T User Manual page 23

Webviewer - Settings
Network
View the camera's network information.
1
IP Address
1. Dynamic IP - Select Dynamic IP if you are using a DHCP
Server. The camera will obtain all its network information
automatically from the server.
2. If you do not have a DHCP server, or wish to manually
enter the camera's network information, select static IP
Address from the drop-down options. Contact you Inter-
net Service Provider(ISP) or Network Administrator for
more information.
2
Subnet Mask
The camera is set to DHCP. Subnet will change according
to network settings.
3
Gateway
This is your router's external IP address. This address is used
when accessing the camera remotely from outside the
network. The router will channel the data request to the
appropriate port associated with the camera.
4
Default DNS
Enter a Domain Name Server(DNS) address. This translates
a web addresses to an IP addresses.
5
IPv4 Link Local Network Setting
Enabled by default.
1. IP Address, Subnet Mask
These are set automatically based on you settings in the
Network Setting section.
6
IPv6 Network Setting
Disabled by default.
1. Manually set the camera's IP address and gateway.
The number next to "/" on IPv6 Address are setting value
for the sub-network.
2. IPv6 LinkLocal - Set automatically by the commnuication
between the local network devices. This is disabled by
default.
7
Link Speed / Duplex Mode
If the auto negotiation mode has a problem with the conn-
ected network device, use a specified value. The value of
the camera and the network device should be the same.
8
Status
The status of the current network connection.
9
Click OK to apply any changes to the settings.