Webviewer - Settings
Motion Detection
To setup a motion detection mask on the camera's view, click on any point in the camera's preview and drag to make a
detection range. nce a motion detection mask is set, a red mark will appear on the upper bar of the video image on the web
monitoring page. The camera supports four different motion detection masks
individually be selecting the appropriate tab.
1
Fill All
If enabled, the entire camera's FoV will be set to motion
detection.
2
Clear All
Deselects the selected area.
3
Invert
Inverts the selected area.
4
Enable
Check the box for the activation.
5
Sensitivity
The higher the value, the more sensitive to motion the area
will be.
6
Threshold
When the ratio of the moving parts to the whole image is
on the range, the detection is checked.
7
Click OK to apply any changes to the settings.
. Each one can be setup