Digital Watchdog DWC-PB6M4T User Manual page 24

Webviewer - Settings
Panorama Camera Setup
Set the camera's common options.
1
BW/Color/Auto
Auto : The camera will switch between color and BW based
on the AGC levels.
BW : The camera will remain in BW mode regardless of the
lighting environment.
Color : The camera will remain in COLOR mode regardless
of the lighting environment.
2
HLC/BLC/WDR
HLC : HLC allows objects to appear clearly on the screen by
masking extremely bright areas.
BLC : BLC is used to improve the image quality in the back-
light state.
WDR : Depends on the difference in brightness between
the darkest and lightest part of and image.
3
Brightness
Set the brightness of the camera's image from 0~20. The
higher the number, the brighter the camera's image will
appear. Default is 10.
4
Sharpness
Sets the image sharpness. The highter the number, the
sharper the image.
5
Saturation
The higher the number, the more vibrant the colors will
appear on the camera's image. The lower the number, the
more black and white the image will appear.
Default value is 10.
6
NTSC/PAL
The camera will switch between NTSC and PAL.
NTSC 60Hz / PAL 50Hz.
7
Operate Mode
The camera will switch between Seperate mode and
Center Sync. Center Sync adjusts White Balance according
to the center.
8
Shutter mode
If Shutter is set to Auto, shutter speed is adjusted automa-
tically accroding to the surrounding illumination.
9
Shutter speed
The faster the shutter speed is, moving objects will appear
without ghosting effect. However, this will also cause the
picture to appear darker if there is no sufficient lighting.
This menu is activated when Shutter is set to Manual.
10
Camera Control (Not supported)
Only Zoom, Focus buttons on the PTZ panel are availabel.
"F" means Focus and "Z" means Zoom.
11
Stitch
Adjust the video position of each individual lens. Select a
"CH" and adjust the position by using buttons.
Load Data : Restore last saved values.
Factory Data : Restore the default value.