Figure 48: Lcd Panel In An Ex3200, Ex4200, Ex4500, Ex4550, Or Ex8200; Figure 49: Lcd Panel In An Ex4300 Switch - Juniper EX4500 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
To connect and configure the switch by using the J-Web interface:
Transition the switch into initial setup mode:
1.
EX2200 and EX2200-C switch—Press the mode button located on the lower right
corner of the front panel for 10 seconds.
EX3200, EX3300, EX4200, EX4300, EX4500, EX4550, EX6200, or EX8200
switch—Use the
Menu
Figure 48 on page 163

Figure 48: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200

Switch

Figure 49: LCD Panel in an EX4300 Switch

1— LCD panel
2— LCD panel Enter button
Press the button until you see
Menu
1.
button.
Press until you see
2. Menu
If EZSetup does not appear as an option in the menu, select
return the switch to the factory default configuration. EZSetup is displayed in
the menu of standalone switches only when a switch is set to the factory default
configuration.
Press to confirm setup and continue with EZSetup.
3. Enter
Connect the Ethernet cable from the Ethernet port on the PC to the switch.
2.
EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (ge-0/0/0) on
the front panel of the switch.
EX3300, EX4500, or EX4550 switch—Connect the cable to the port labeled
on the front panel (LCD panel side) of the switch.
EX4300 switch—Connect the cable to the port labeled
the switch.
Chapter 15: Performing Initial Configuration
and buttons located to the right of the LCD panel (see
Enter
or Figure 49 on page 163):
3— LCD panel Menu button
4— Chassis status LEDs
MAINTENANCE MENU
. Then press
ENTER EZSetup
. Then press the
Enter
.
Enter
to
Factory Default
MGMT
on the rear panel of
MGMT
163