Juniper EX4500 Hardware Manual page 183

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Use the Management Options page to select the management scenario:
6.
NOTE: On EX4500, EX6200, and EX8200 switches, only the out-of-band
management option is available.
Configure in-band management. In in-band management, you configure a network
interface or an uplink module (expansion module) interface as the management
interface and connect it to the management device.
In this scenario, you have the following two options:
Use the automatically created VLAN default for management—Select this option
to configure all data interfaces as members of the default VLAN. Specify the
management IP address and the default gateway.
Create a new VLAN for management—Select this option to create a management
VLAN. Specify the VLAN name, VLAN ID, management IP address, and default
gateway. Select the ports that must be part of this VLAN.
Configure out-of-band management—Configure the management port. In
out-of-band management, you use a dedicated management channel (
to connect to the management device. Specify the IP address and gateway of the
management interface. Use this IP address to connect to the switch.
Specify the SNMP read community, location, and contact to configure SNMP
7.
parameters. These parameters are optional.
Specify the system date and time. Select the time zone from the list. These options
8.
are optional.
The configured parameters are displayed. Enter yes to commit the configuration. The
9.
configuration is committed as the active configuration for the switch.
(For EX4500 switches only) Enter the operational mode command request chassis
10.
pic-mode intraconnect to set the PIC mode to intraconnect.
You can now log in with the CLI or the J-Web interface to continue configuring the switch.
If you use the J-Web interface to continue configuring the switch, the Web session is
redirected to the new management IP address. If the connection cannot be made, the
J-Web interface displays instructions for starting a J-Web session.
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 162
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX2300 Switch
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX3300 Switch
Installing and Connecting an EX3400 Switch
Chapter 15: Performing Initial Configuration
MGMT
port)
161