Wan - TP-Link PHAROS SERIES User Manual

WAN

NOTE:
WAN submenu is only available on AP router mode and AP client router (WISP Client) mode.
There are five WAN connection types: Static, Dynamic, PPPoE, L2TP, and PPTP. Select the suitable one to
configure the IP parameters of the WAN on the screen below. If you are not sure of the connection type to
use, please consult your ISP.
Static

This connection type uses a permanent, fixed (static) IP address that your ISP assigned. In this type, you
should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually, which are specified by
your ISP.
IP Address
Netmask
Gateway IP
Primary DNS
Enter the IP address provided by your ISP.
Enter the Netmask provided by your ISP. Normally use 255.255.255.0 as the
netmask.
Enter the gateway IP address provided by your ISP.
Enter the DNS IP address provided by your ISP.
- 38 -
Chapter 5 Network Tab