TP-Link PHAROS SERIES User Manual page 32

Max TX Rate
Distance
Wireless Signal Quality

Status of wireless signal quality displays the parameters of the received wireless signal in the modes of
Client, Repeater (Range Extender), Bridge and AP Client Router. The parameters here is not applicable for
other two modes.
Signal Strength Displays the received wireless signal strength of the root AP.
Noise Strength Displays the received environmental noise from wireless interference on the
operating frequency.
SNR Signal to Noise Ratio, the power ratio between the received wireless signal strength
and the environmental noise strength. Generally, in order to achieve the best
performance, users need to adjust the antenna to get the best SNR.
Transmit CCQ Displays the wireless Client Connection Quality (CCQ). CCQ refers to the ratio of
current effective transmission bandwidth and the theoretically maximum available
bandwidth. CCQ reflects the actual link condition.
Radio Status

Radio status shows the MAC address, SSID, security mode and connected station number of the enabled
AP. If the Client mode is enabled, the information of MAC address, security mode, WDS, root AP BSSID, root
AP SSID, TX rate, RX rate and connection time of the client will also be displayed.
Displays the data rate at which the device should transmit wireless packets.
Displays the wireless coverage distance where the client devices can be placed
from the AP to get good wireless performance. You can change the value in
Wireless Advanced Settings.
- 29 -
Chapter 4 Status Tab