Web Server - TP-Link PHAROS SERIES User Manual

Web Server

The Web Server function enables users to log in to the web management page to manage this device
remotely over the Internet.
Secure Connection (HTTPS)
Secure Server Port
Server Port
Remote Login IP Address
Session Timeout
MAC Authentication
The Secure Connection (HTTPS) mode is enabled by default.
Specify the server port that the Web server uses in the
(HTTPS) mode, and the default is 443.
Specify the server port that the Web server uses in the
default is 80.
Configure the IP address that can remotely visit the web management page of
this device. Enter 0.0.0.0 to forbid any remote IP's login. Enter 255.255.255.255 to
allow all the remote IP to visit.
Enter the maximum timeout before the session expires. Once a session expires,
you must log in again using the username and password.
Enable this function to allow PCs with specific MAC addresses to access the web
management page. And then enter each MAC address in the MAC field. The
format for the MAC addresses is XX-XX-XX-XX-XX-XX. Only the PCs with the MAC
addresses listed can use the password to access the device's web management
page and the others will be blocked. By default, the function is not enabled. All
the PCs in the local area network are allowed to access the device's web
management page.
Click Add PC's MAC, your PC's MAC address will be added in the list above. Click
Apply to save your settings.
- 73 -
Chapter 7 Management Tab
Secure Connection
HTTP mode, and the