TP-Link PHAROS SERIES User Manual page 36

SNR (dB)
CCQ (%)
Rate (Mbps)
RX (kbps)
TX (kbps)
Auto Refresh
Interfaces

The table displays the relevant information of each interface including MAC, IP address, etc.
MAC
IP Address
MTU
RX packets
RX Bytes
TX packets
TX Byte
Auto Refresh
Signal to Noise Ratio, the power ratio between the received wireless signal
strength and the environmental noise strength. Generally, in order to achieve
the best performance, users need to adjust the antenna to get the best SNR.
Displays the wireless Client Connection Quality (CCQ) of the station.
Displays the station's data rates of the last transmitted packets.
Displays the station's average data rates of the received packet over the
connection time.
Displays the station's average data rates of the transmitted packets over the
connection time.
If Auto Refresh is checked, parameters in the table will refresh automatically.
Displays the MAC address of the interface.
Displays the IP address of the interface.
Displays the Maximum Transmission Unit (MTU), which is the maximum packet
size (in bytes) that a network interface can transmit.
Displays the total amount of packets received by the interface after the device is
powered on.
Displays the total amount of data (in bytes) received by the interface after the
device is powered on.
Displays the total amount of packets transmitted by the interface after the device
is powered on.
Displays the total amount of data (in bytes) transmitted by the interface after the
device is powered on.
If Auto Refresh is checked, parameters in the table will refresh automatically.
- 33 -
Chapter 4 Status Tab