TP-Link PHAROS SERIES User Manual page 48

Hide thumbs Also See for PHAROS SERIES:
Table of Contents

Advertisement

Connection type
IP Address
Netmask
IGMP Proxy
DHCP Server
Fallback IP
DHCP Fallback IP
DHCP Fallback Mask
Start IP Address
End IP Address
Default Gateway
Default Domain
Primary DNS
Secondary DNS
Lease Time
There is only one LAN Connection type Static in AP Router mode and AP Client
Router (WISP Client) mode. While there are Static and Dynamic of Connection
types in Access Point mode, Client mode, Repeater (Range Extender) mode and
Bridge mode.
Enter the IP address of your AP/router (factory default: 192.168.0.254).
Enter the Netmask provided by your ISP. Normally use 255.255.255.0 as the
netmask.
IGMP (Internet Group Management Protocol) works for IPTV multicast stream. If
you want to watch IPTV, please Enable it.
If the built-in DHCP server is expected to assign IP addresses to clients connected
to the wireless interface and LAN interface, please Enable it.
When Dynamic IP is selected as the connection type, you can enable this function.
The fallback IP will be used as the LAN IP when a DHCP server is not found.
Specify the IP address for the device to use if a DHCP server is not found.
Specify the mask for the device to use if a DHCP server is not found.
This field specifies the first address in the IP Address pool. 192.168.0.100 is the
default start IP address.
This field specifies the last address in the IP Address pool. 192.168.0.199 is the
default end IP address.
Enter the IP address of the gateway for your LAN. The factory default setting is
192.168.0.254.
Enter the domain name of your DHCP server. You can leave the field blank.
Enter the DNS IP address provided by your ISP. Please consult your ISP if you don't
know the DNS value. The factory default setting is 0.0.0.0.
Enter the IP address of alternative DNS server if your ISP provides two DNS servers.
The factory default setting is 0.0.0.0.
Enter the amount time of the leased IP address assigned by the DHCP server.
Before the time is up, DHCP client will request to renew the lease automatically
and DHCP server would not assign this IP address to other clients.
- 45 -
Chapter 5 Network Tab

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents