GE D60 Instruction Manual page 237

5 SETTINGS
EXAMPLE USE OF SOURCES:
An example of the use of sources is shown in the diagram below. A relay could have the following hardware configuration:
INCREASING SLOT POSITION LETTER -->
CT/VT MODULE 1 CT/VT MODULE 2
CTs VTs
This configuration could be used on a two-winding transformer, with one winding connected into a breaker-and-a-half sys-
tem. The following figure shows the arrangement of sources used to provide the functions required in this application, and
the CT/VT inputs that are used to provide the data.
Y LV
SRC 1
Phase CT M1
Ground CT M1
Phase VT M5
Aux VT None
GE Multilin
CT/VT MODULE 3
not applicable
Figure 5–26: EXAMPLE USE OF SOURCES
D HV AUX
SRC 2 SRC 3
F1+F5 None
None None
None None
None U1
D60 Line Distance Protection System
5.4 SYSTEM SETUP
5
5-103