Siemens SIMATIC ET 200SP Manual page 76

Drivers, parameters, diagnostics messages and address space
A.9 Address space in mixed mode
EB x +
58
59
:
62
63
Output range
QB x +
0
1
2...
The HART range is only available with configuration in mixed mode with 1 multiHART range
or 4 multiHART ranges in the input/output area
There is 1 byte of command for each multiHART range.
With configuration in mixed mode with 1 multiHART range in the input/output area:
QB x + 2
With configuration in mixed mode with 4 multiHART ranges in the input/output area:
QB x + 2
:
:
QB x + 5
Evaluating value status
There is one bit of value status in the address space for each digital output and each digital
input.
When the module is configured in mixed mode, there is also one bit of value status for each
analog input.
Irrespective of the diagnostics enables, each value status (each QI bit) provides information
on the validity of the corresponding process value.
● Value status = 1: Process value okay, "good"
● Value status = 0: Process value not OK, "bad"
Note
The value status is not set to "bad" when there is a wire break on the channel and the wire
break test is disabled.
76
HART range
Acknowledgment
Value HART variable
QC
7 6 5
DQ7 DQ6 DQ5
DQ15 DQ14 DQ13
HART range
Command
Command
Command
Input/output module AI-DI 16/DQ16x24VDC HART HA (6DL1133-6EW00-0PH1)
multiHART range 3
4 3 2
DQ4 DQ3 DQ2
DQ12 DQ11 DQ10
multiHART range
multiHART range 0
multiHART range 3
Manual, 05/2017, A5E39294170-AA
1 0
DQ1 DQ0
DQ9 DQ8