Siemens SIMATIC ET 200SP Manual page 19

Parameters
Diagnostics encoder supply
Hardware interrupt, rising edge
Hardware interrupt, falling edge
Pulse stretching
The wire break diagnostics can only be enabled when the "Check for wire break" parameter is enabled.
1
Parameters in mixed mode
The following settings are available when the I/O module is configured in mixed mode:
Parameter
Diagnostics, Missing supply
voltage L+
IO redundancy
Potential group
Parameters of the digital outputs
Channel mode DO
Diagnostics
Short-circuit to ground
Diagnostics
Wire break
1
Wire break test
Input/output module AI-DI 16/DQ16x24VDC HART HA (6DL1133-6EW00-0PH1)
Manual, 05/2017, A5E39294170-AA
Value range
● Enabled
● Disabled
● Enabled
● Disabled
● Enabled
● Disabled
● None
● 0.05 s
● 0.1 s
● 0.2 s
● 0.5 s
● 1 s
● 2 s
Value range
● Enabled
● Disabled
● None
● 2 modules
● Use potential group of the left
module
● Allow new potential group
● Enabled
● Disabled
● Sensor supply
● Enabled
● Disabled
● Enabled
● Disabled
● Enabled
● Disabled
4.2 Module/channel parameters
Default
Disabled
Disabled
Disabled
None
Default Parame‐
ter reas‐
signment
in RUN
Enabled Yes
None Yes
Use potential group No
of the left module
Sensor supply Yes
Enabled Yes
Enabled Yes
Enabled Yes
Parameters
Parameter Efficiency
reassign‐ range
ment in RUN
Yes Channel
Yes Channel
Yes Channel
Yes Channel
Efficiency range
Module
Module
Module
Channel
Channel
Channel
Channel
19