Elo TouchSystems 15D1 User Manual page 45

T 15D1 U
OUCHCOMPUTER
This equipment has been tested to the requirements for the CE Mark as required
by EMC Directive 89/336/EEC indicated in European Standard EN 55022
Class A and the Low Voltage Directive 73/23/EEC as indicated in European
Standard EN 60950.
D. General Information to all Users: This equipment generates, uses, and can
radiate radio frequency energy. If not installed and used according to this
manual, the equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will not
occur in any particular installation due to site-specific factors.
1. In order to meet emission and immunity requirements, the user must
observe the following:
a. Use only the provided I/O cables to connect this digital device with any
computer.
b. To ensure compliance, use only the provided manufacturer's approved
power cord.
c. The user is cautioned that changes or modifications to the equipment
not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
2. If this equipment appears to cause interference with radio or television
reception, or any other device:
a. Verify as an emission source by turning the equipment off and on.
b. If you determine that this equipment is causing the interference, try to
correct the interference by using one or more of the following
measures:
i. Move the digital device away from the affected receiver.
ii. Reposition (turn) the digital device with respect to the affected
receiver.
iii. Reorient the affected receiver's antenna.
iv. Plug the digital device into a different AC outlet so the digital
device and the receiver are on different branch circuits.
v. Disconnect and remove any I/O cables that the digital device does
not use. (Unterminated I/O cables are a potential source of high RF
emission levels.)
vi. Plug the digital device into only a grounded outlet receptacle. Do
not use AC adapter plugs. (Removing or cutting the line cord
ground may increase RF emission levels and may also present a
lethal shock hazard to the user.)
vii. If you need additional help, consult your dealer, manufacturer, or
an experienced radio or television technician.
G
SER UIDE
40