Table of Contents
Advertisement
ZEUS4-VD
11.2 ALARM SUPPORT
Alarm reporting is supported by group of different parameters. First section is used to define the
relations needed for alarm to be trigged. The second section is used to report alarm.
11.2.1
IN Parameters
Alarm and reset input can be triggered in 4 different ways. The status of the input can either be
normal closed (N.C) or normal open (N.O.) with positive (+ 12V) or negative (GND) voltage.
When you need the input feedback information it is possible to receive SMS when input returns
from alarm to normal position. To receive return SMS use IN=4, 5 or 6.
IN = 0 – Normal Open – triggered with negative voltage (GND)
IN = 1 – Normal Close – breaking negative or positive voltage loop
IN = 2 – Normal Open – triggered with positive voltage (+ 12VCC)
IN = 3 – Input disable
IN = 4 = IN = 0 + input reset SMS
IN = 5 = IN = 1 + input reset SMS
IN = 6 = IN = 2 + input reset SMS
Table of parameters:
Name
ION
IN1
IN2
IN3
IN4
INPUT 1-4
INPUT 1-4
N.O.
Contact
GND
+12V DC
Figure 3: Input Connection diagram
System arm/disarm control
Input 1 control
Input 2 control
Input 3 control
Input 4 control
Table 3: IN parameters
12
INPUT 1-4
N.O.
N.C.
Contact
Contact
Comment
INSTALLATION MANUAL
INPUT 1-4
N.O.
N.C.
Contact
Contact
+12V DC
Advertisement
Table of Contents
