Table of Contents
Advertisement
ZEUS4-VD
10 VOICE MESSAGES – RECORD & PLAY
The memory of each alarm input enables us to record our own voice message in the total length of
10 seconds (4 x 10 seconds). The device is namely equipped with a PLAY/REC audio connector.
For recording and listening recorded messages a headset is necessary. Headset is very common and
it is use with many mobile phones but should be supplied also by your distributor.
10.1 RECORDING / LISTENING OF VOICE ALARM MESSAGES
For recording and playing alarm messages ZEUS4-VD has a joystick switch which you can use in 4
different directions:
Message 1 – UP
Message 2 – RIGHT
Message 3 – DOWN
Message 4 – LEFT
10.1.1
RECORDING OF VOICE ALARM MESSAGES:
1. ZEUS4-VD must be in normal operating mode – registered to the GSM network, to avoid
disturbances when logging on to the GSM network.
2. Insert the handset into the PLAY/REC audio connector on PCB.
3. RECORDING: Press and hold the joystick up for recording the 1st message (no beep).
4. The RED LED left of the joystick permanently lit when recording.
5. When release the joystick the RED LED goes OFF.
Follow the same procedure for all four alarm messages.
10.1.2
PLAYBACK OF VOICE ALARM MESSAGES:
1. Shortly press the joystick up for listening the 1st message.
2. You can hear the 1st message.
3. The RED LED left of the joystick blinks when the message is ended.
4. Playback stops automatically after the end of the message.
Follow the same procedure for all four alarm messages.
message 1
message 4
message 3
Figure 2: Recording / Listening of alarm messages
message 2
10
INSTALLATION MANUAL
Advertisement
Table of Contents
