Eneo VKC-1341A/12-24 Installation And Operating Instructions Manual page 40

NOTE: • When using an auto iris lens, the setting of the auto iris lens selection switch,
located on the back of the camera, must be on DC or VIDEO depending on the
type of the lens which is being used.
• The brightness of the screen can be adjusted in DC mode. The brightness can
be adjusted within the range of 0~70. The optimum level of brightness for the
user can be achieved by adjustment.
When using Auto Iris Lens with Video type
) Adjust ALC volume on the lens properly. Normally ALC volume should be turned all
the way to Av (Average).
) According to the type of the lens used, the lens may not perform properly. In such a
case, adjust the volume level on the lens.
3) For adjusting the Volume Level, enter the submenu at the „VIDEO LENS" mode.
And then adjust it to the desired state.
NOTES: When the auto iris is mounted, you have to set the DC/Video selection
switch on the side of
the camera properly according to status of this selection switch.
• SENS-UP (Low illuminance)
SENS UP helps maintain a bright, clear screen image by automatically detecting changes in
the level of light in low light level conditions.
• OFF
The function does not operate.
• AUTO
Low light level auto mode. x ~ x8
NOTE: • When SHUTTER is in the manual mode, SENS UP does not operate.
• When AGC is turned off. SENS UP does not operate.
NOTE: • The maximum storage magnification in low light level movement situations can
be adjusted by pressing the ENTER button in „AUTO" mode. (x2 ~ x128)
• As the magnification increase, the screen gets brighter; however the after
image also increases.
• If storage magnification is increased while SENS UP is operating, it may cause
noise, and spots may appear; however this is normal.
• END
RETURN to the MAIN MENU
40