Modifying The Pim Router-Query Message Interval; Configuring Optional Igmp Features - Cisco Catalyst 3750-X Software Configuration Manual

Configuring Optional IGMP Features

Command
Step 4
end
Step 5
show running-config
Step 6 copy running-config startup-config
To return to the default setting, use the no ip pim spt-threshold {kbps | infinity} global configuration
command.

Modifying the PIM Router-Query Message Interval

PIM routers and multilayer switches send PIM router-query messages to find which device will be the
DR for each LAN segment (subnet). The DR is responsible for sending IGMP host-query messages to
all hosts on the directly connected LAN.
With PIM DM operation, the DR has meani n g only if IGMPv1 is in use. IGMPv1 does not have an IGMP
querier election process, so the elected DR functions as the IGMP querier. With PIM-SM operation, the
DR is the device that is directly connected to the multicast source. It sends PIM register messages to
notify the RP that multicast traffic from a source needs to be forwarded down the shared tree. In this
case, the DR is the device with the highest IP address.
Beginning in privileged EXEC mode, follow these steps to modify the router-query message interval.
This procedure is optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 ip pim query-interval seconds
Step 4 end
show ip igmp interface [interface-id]
Step 5
Step 6
copy running-config startup-config
To return to the default setting, use the no ip pim query-interval [seconds] interface configuration
command.
Configuring Optional IGMP Features
•
•
•
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
48-38
Default IGMP Configuration, page 48-39
Configuring the Switch as a Member of a Group, page 48-39
Controlling Access to IP Multicast Groups, page 48-40
Changing the IGMP Version, page 48-41
Modifying the IGMP Host-Query Message Interval, page 48-42
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Configure the frequency at which the switch sends PIM router-query
messages.
The default is 30 seconds. The range is 1 to 65535.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
(optional)
Chapter 48 Configuring IP Multicast Routing
(optional)
(optional)
(optional)
OL-21521-01