Install RAM Mount
CAUTION - This device is intended to transmit RF energy. For protection against RF exposure to humans and in accor-
dance with FCC rules and Industry Canada rules, this transmitter should be installed such that a minimum separation dis-
tance of at least 20 cm (7.8 in.) is maintained between the antenna and the general population. This device is not to be
co-located with other transmitters.
Before installation begins, verify you have the applicable vehicle mounting bracket assembly components necessary, as shown
in the following figures.
Components - RAM Mounting Kits
Mounting kits that do not include an external keyboard are shown below. Mounting kits that include a provision for an exter-
nal keyboard include the parts on this page plus the parts on the next page.
In addition to the kits below, individual RAM mounting components are also available.
Mounting Kits without Keyboards
Each mounting kit contains:
RAM Ball (Size D) for back of Thor VM2 dock with hardware (screws and washers) to
attach RAM ball to dock
RAM Arm (Size D), length varies by kit selected
One of three mounting options:
• RAM Ball mount (Size D, may include 3 cone washers), or
• RAM Clamp mount (Size D), or
4 - 4