Honeywell Thor VM2 User Manual page 113

1. Scan the Bluetooth address bar code label, attached to the Thor VM2, with the Bluetooth mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the Thor VM2 Bluetooth label, the devices are
paired. See section titled
cessfully, go to the next step.
3. Open the EZPair panel (
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the Thor VM2 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps and an LED flashes.
Refer to the following section titled
Note: After scanning the Thor VM2 Bluetooth label, if there is no beep and no LED flash from the Bluetooth
device, the devices are currently paired.
Thor VM2 without Label
If the Thor VM2 Bluetooth address bar code label does not exist, follow these steps to create a unique Blue-
tooth address bar code for the Thor VM2:
Next, create a Bluetooth address bar code label for the Thor VM2.
The format for the bar code label is as follows:
• Bar code type must be Code 128.
• FNC3 character followed by string Uppercase L, lowercase n, lowercase k, uppercase B and then the
Bluetooth address (12 hex digits, no colons). For example, LnkB0400fd002031.
Create and print the label.
Scan the Thor VM2 Bluetooth address bar code label with the Bluetooth bar code reader.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps and LED flashes.
Note: After scanning the Thor VM2 Bluetooth label, if there is no beep and no LED flash from the Bluetooth
bar code reader, the devices are currently paired.
See Bluetooth Beep and LED Indications (page
Bluetooth Beep and LED Indications
(Start) > Control Panel > Bluetooth).
Bluetooth Beep and LED Indications
5-16).
(page 5-16). If the devices do not pair suc-
(page 5-16).
5 - 15