Honeywell Thor VM2 User Manual page 51

Step 1b – Mount RAM Clamp to Vehicle
Note: If you are using the RAM ball mount, please go to
using the RAM plate mount, please go to
1. Determine the position for mounting the RAM clamp mount. The clamp mount can be used on a beam (such as on
a fork lift truck) up to 2.5" (63.5 mm) wide and approximately 2" (50.8 mm) thick. The clamp may be attached to a
thicker beam by substituting longer bolts (not included). Be sure to position the RAM clamp mount to allow access
to the switches and ports on the bottom of the Thor VM2.
Bolts
Upper clamp piece
Lower clamp piece
Nuts
2. Position the upper clamp piece with ball on the beam. Place the bolts through the holes in the upper clamp piece.
3. Position the lower clamp piece below the beam. Align the bolts with the holes in the lower clamp piece.
4. Place the nylon locking nuts on the bolts and tighten the bolts.
Mounting Dimensions
Note: Drawing not to scale.
2.56" /
1.84" (46.74mm)
65.02mm
Step 1a – Attach RAM Ball to Vehicle
Step 1c – Attach RAM Plate to Vehicle and Attach RAM Ball
(page 4-6). If you are
(page 4-8).
4 - 7