Honeywell Thor VM2 User Manual page 156

Example 3: Apply settings
CCU.exe -apply -reset -e:\myfile.ccf
Use this command line example to read the settings from the specified ccf file and apply them to the Thor VM2 running
the CCC.
Where:
apply directs the CCU to read the settings from the ccf file and apply them to the system registry.
reset is optional. When -reset is specified, all setting are reset to their default values before the customized settings in
the ccf file are applied. Any prior changes made to these settings on the Thor VM2 are lost. If -reset is not specified,
only the changed values in the ccf file are applied. Any other setting previously made on the Thor VM2 are retained.
E:\myfile.ccf is the path and filename of the ccf file containing the changes to be applied. If the path is not specified,
the ccf file must be located at C:\Windows\DDF.
Note: After using the -apply parameter, the Thor VM2 must be rebooted for the changes to take effect.
CCU.exe -apply -e:\myfile.ccf
The example above applies the settings from the ccf file to the device leaving all other settings untouched.
CCU.exe -apply -reset -e:\myfile.ccf
The example above resets all values to defaults then applies the settings to the device.
5 - 58