Power Up - Honeywell Thor VM2 User Manual

Power Up

If a USB drive, such as a thumb drive is attached to the Thor VM2, the device attempts to boot from the USB drive and
cannot. Remove the USB drive and power up the Thor VM2 again.
The dock has a power switch on the back.
The "On" side of this rocker switch has a raised bump to allow the state of the switch to be determined when the switch may not
be easily viewed, for example, after the dock is mounted in a vehicle.
After external power has been connected and the Thor VM2 has been mounted in the dock, press the side of the power switch
with the raised bump to pass power from the dock to the Thor VM2.
Next locate the power button on the front of the Thor VM2.
Press the power button to turn the Thor VM2 on. When the Windows desktop is displayed or an application begins, the power up
sequence is complete.
See Power Controls (page 3-5) for more information.
2 - 8