Table 40 Maintenance > Remote Management > WAN Access
LABEL
Secured Client IP
Address
Apply
Cancel
14.10 Log Screen
The Web Configurator allows you to look at all of the NBG6604's logs in one location.
You can configure which logs to display in the Log screen. Select the logs you wish to display. Click
Apply to save your settings. Click Cancel to start the screen afresh.
Use this screen to see the logged messages for the NBG6604. The log wraps around and deletes the old
entries after it fills. Select the logs you want to see from the Display drop list. The log choices depend on
your settings above this screen. Click Refresh to renew the log screen. Click Clear Log to delete all the
logs.
Figure 65 Maintenance > Log
14.11 System Operation Mode Overview
The Sys OP Mode (System Operation Mode) function lets you configure your NBG6604 as a router or
access point. You can choose between Router Mode and Access Point Mode depending on your
network topology and the features you require from your device.
The following describes the device modes available in your NBG6604.
Chapter 14 Maintenance
DESCRIPTION
Select All to allow all computes to access the NBG6604.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG6604.
Click Apply to save your changes back to the NBG6604.
Click Cancel to begin configuring this screen afresh.
NBG6604 User's Guide
98