Wan Selection Type: Static - ZyXEL Communications NBG6604 User Manual

By implementing PPPoE directly on the NBG6604 (rather than individual computers), the computers on
the LAN do not need PPPoE software installed, since the NBG6604 does that part of the task.
Furthermore, with NAT, all of the LAN's computers will have Internet access.
WAN Selection Type: PPPoE
Figure 10
The following table describes the labels in this screen.
Table 6 WAN Selection Type: PPPoE
LABEL
WAN Selection
PPPoE Username
PPPoE Password
Static IP (Optional)
Note: If you get an error message, make sure you have entered the correct information
provided by your ISP.

3.3.3 WAN Selection Type: Static

Choose Static as the WAN Selection Type when the WAN port is used as a regular Ethernet. Click Next.
Chapter 3 eaZy 123 Wizard
DESCRIPTION
Select the PPPoE (Point-to-Point Protocol over Ethernet) option for a dial-up connection.
Type the user name given to you by your ISP.
Type the password associated with the user name above.
Enter the WAN IP address assigned by your ISP.
NBG6604 User's Guide
21