3.2.5 Removing the DVD servo board
(See fig.7 and 8)
• Remove the DVD cover and traverse mechanism.
(1) The short land section b of a pickup is soldered. (See fig.7)
Caution:
• Please solder to the short land section b of a pickup
before removing a card wire from the connector
CN101
of a DVD servo board.
If a card wire is removed without soldering, a pickup
may be destroyed by static electricity. (See fig.7 and 8)
• At the time of DVD servo board attachment, please re-
move the solder of the short land section b of a pickup
after attaching a card wire in a connector CN101. (See
fig.7 and 8)
(2) The lock of connector
moved in the direction of an arrow, and a card wire is re-
moved. (See fig.8)
(3) Remove the two screws D attaching the DVD servo board
from bottom surface of traverse mechanism assembly.
(See fig.8)
(4) Remove the card wire from connector
board. (See fig.8)
(5) A DVD servo board is raised from the connection part c,
and it removes in the direction of an arrow from hook d.
(See fig.8)
CN101
of a DVD servo board is re-
CN201
of DVD servo
b
Traverse mechanism assembly
Fig.7
Card wire
D
CN101
DVD servo board
Traverse mechanism assembly
Fig.8
DVD pickup
Card wire
CN201
c
D
(No.MB496)1-23