JVC UX-QD70S Service Manual page 10

3.1.2 Removing the side panels (L)/(R)
(See Fig.3)
• Remove the rear cover(B).
(1) From the bottom side of the main body, remove the two
screws C attaching the side panels (L)/(R).
(2) Slide the side panels (L)/(R) in the direction of the arrow
and remove the side panels (L)/(R).
3.1.3 Removing the top cover assembly
(See Figs.4 and 5)
• Remove the rear cover(B) and side panels(L)/(R).
(1) From the left side of the main body, disconnect the card
wires from the connectors (CN703, CN709) on the micon
board. (See Fig.4.)
(2) Remove the screw D attaching the top cover assembly.
(See Fig.4.)
(3) From the right side of the main body, disconnect the card
wire from the connector
Fig.5.)
(4) Disconnect the wire from the connector
board. (See Fig.5.)
(5) From the both sides of the main body, remove the two
screws E attaching the top cover assembly. (See Figs.4
and 5.)
(6) Release the joints a and remove the top cover assembly.
(See Figs.4 and 5.)
1-10 (No.MB496)
CN105 on the main board. (See
CN108 on the main
C
Side panel (R)
C
Side panel (L)
Fig.3
D
Top cover assembly
CN703 CN709
Fig.4
Top cover assembly
E
a
Main board
Fig.5
E
a
Micon board
CN105
CN108