Interrogating The Listen-In Time; Call Delay; Programming The Call Delay - Sensaphone 1108 User Manual

4.7.2 Interrogating the Listen-in Time

To interrogate the Listen-in Time:
1. Press WHAT IS.
2. Press LISTEN TIME. The Model 1108 will recite the listen
time in seconds programmed.

4.8 Call Delay

Call Delay is the programmed length of time the Model 1108
waits, following detection of an alarm, before it begins the dial-
out sequence. This applies only to the first call. (Delay time
between calls is also programmable: refer to Intercall Time,
Section 4-11.)
The purpose for Call Delay is to allow time for personnel at the
Model 1108's installation site to respond to and cancel an alarm
before dial-out begins. During this time, the Model 1108 will
audibly repeat its "alert condition" message (unless the Local
Voice Mute feature has been activated—refer to Section 4.9). The
default for Call Delay is 30 seconds. Call Delay can be
programmed from 0 seconds to 60 minutes (1 hour).

4.8.1 Programming the Call Delay

To program the Call Delay:
1. Press SET.
2. Press CALL DELAY.
The Model 1108 will respond: "Enter minutes. "
Chapter 4: Communications Programming
55