Sensaphone 1104 Addendum
Cottage sitter addendum
Hide thumbs
Also See for Sensaphone 1104:
- User manual (108 pages) ,
- Owner's manual addendum (6 pages) ,
- User manual (6 pages)
Related Manuals for Sensaphone Sensaphone 1104
Summary of Contents for Sensaphone Sensaphone 1104
- Page 1 SENSAPHONE ® Model 1104/08 CottageSitter Addendum Your local CottageSitter dealer:...
- Page 2 Model 1104/08 Owner’s Manual Addendum Sensaphone CottageSitter How to use this Addendum This is a supplement to the Sensaphone 1104/08 Owner’s Manual. Review the entire manual before reading this addendum. This addendum does not explain the Sensaphone setup, configuration, or operation. The purpose of this addendum is to instruct you on...
- Page 3 CottageSitter Addendum NOTE: For safety reasons it is highly recommended that the unit only be used to switch low voltage signals (30 volts or less). If you intend to control higher voltages you must install the unit in an NEC approved electrical panel or enclosure and have wiring performed by a qualified electrician.
- Page 4 Sensaphone ® Model 1104/1108 User’s Manual 3. Press pound # 3 to turn OFF the output. The Sensaphone will respond “OFF. ” 4. To check the present state of the relay press # 2. This initiates a full recitation of the Status Report. At the end of the status report, the Sensaphone will say “Number five On/Off”...
- Page 5 CottageSitter Addendum “away” temperature and the other thermostat is set to your preferred “home” temperature. With your Sensaphone CottageSitter, you will be able to switch between these two thermostats. Ideally, the “away” thermostat would be in your pump or furnace room.
- Page 6 Sensaphone ® Model 1104/1108 User’s Manual The Sensaphone Setback Thermostat By replacing your existing thermostat with the Sensaphone Setback Thermostat (sold separately), the control of your furnace is done through one thermostat that is pre-programmed with an “away” and a “home” temperature setting. The Sensaphone Setback Thermostat has an LCD readout that lets you enter the desired setpoint for both your “away”...
- Page 7 CottageSitter Addendum Controlling Lights or other devices with Sensaphone Using X10 technology, you can remotely activate any electrical device or appliance in your home through your Sensaphone. X10 technology is a suite of control modules that plug into your existing electrical outlets and transmit coded signals to lamps, lights, and appliances to turn them on or off (See Figure 3).
- Page 8 SENSAPHONE, INC. also cannot guarantee that changes in equipment made by other manufacturers, referred to in this addendum, will not affect the applicability of the information herein. Addendum © 2002 by Phonetics, Inc.
Need help?
Do you have a question about the Sensaphone 1104 and is the answer not in the manual?
Questions and answers