Switching The Output Over The Telephone - Sensaphone 1108 User Manual
Sensaphone telephone
Hide thumbs
Also See for 1108:
- Owner's manual addendum (6 pages) ,
- Addendum (8 pages) ,
- User manual (6 pages)
Table of Contents
Advertisement
2. Press 6.
6
CALIBRATE
To switch the output OFF from the keypad:
1. Press STATUS.
STATUS
CONFIGURE
2. Press 3.
3
INTERCALL
TIME
8.3.2 Switching the Output over the Telephone
1. Call the Sensaphone. When the unit answers it will begin
reciting a status report. At any time during the call, press a
touch-tone. The unit will respond with "OK. " The Sensaphone
is now ready to accept touch-tone commands.
2.
On your phone, press # 6 to turn ON the output. The
Sensaphone will respond "ON. "
3. Press # 3 to turn OFF the output. The Sensaphone will
respond "OFF. "
4. To check the present state of the relay press # 2.
This initiates a full recitation of the Status Report. At the end of
the status report, the Sensaphone will say "Number nine On/Off. "
+
+
+
Chapter 8: Special Editions
109
Hide quick links:
Advertisement
Table of Contents
