NTT docomo P-06C STYLE Series Instruction Manual page 48

Terminal Security Code
This is a four-to-eight digit number for deleting all fi les or
changing settings. When the display for entering the Terminal
Security Code appears, enter your four-to-eight digit code
o ( O
and press
To change
1. m
▶ ▶
Setting Lock/Security
Network Security Code
This is a four-digit number required for your identifi cation
when you place an order at a docomo Shop, docomo
Information Center, or "お客様サポート (User support)" site,
or when you use respective network services.
⿠"お客様サポート (User support)" is available in Japanese only.
To change
From i-mode, you can change your Network Security Code by
selecting "iMenu"→"お客様サポート (User support)"→
"各種設定 （確認 ・ 変更 ・ 利用） [Respective settings (Confi rmation/
Change/Use)]"→"ネットワーク暗証番号変更 (Change Network
Security Code)".
i-mode Password
This is a four-digit number required for registering/deleting
My Menu, applying for/canceling Message Services or i-mode
pay services, etc.
To change
From i-mode, you can change your i-mode password by
selecting "iMenu"→"English"→"Options"
→"Change i-mode Password".
46
"0000" at purchase
).
▶
Change security code
Determining at the time of contract
"0000" at the time of your contract
PIN1 Code/ PIN2 Code
For the UIM, you can set two security codes, namely the PIN1
code and PIN2 code.
The PIN1 code is a four-to-eight digit number for checking
the user each time the UIM is inserted into the FOMA terminal
or each time the FOMA terminal is turned on, to prevent the
unauthorized use by a third party.
The PIN2 code is a four-to-eight digit number for executing
Reset Total, using the user certifi cate or applying for the issue
of it, etc.
When the PIN1 Code/PIN2 Code entry display appears, enter
your four-to-eight digit PIN1 code/PIN2 code and press
o ( O
).
⿠If you enter a wrong PIN1 code/PIN2 code three times in
succession, the FOMA terminal locks and cannot be used.
To change
1. m
▶ Setting ▶ Lock/Security
2. Enter your Terminal Security Code
▶
Select "Change PIN1 code" or "Change PIN2 code".
⿠You need to set "PIN1 code entry set" to "ON" to change the
PIN1 code in advance.
"0000" at the time of your contract
▶ UIM setting