NTT docomo P-06C STYLE Series Instruction Manual page 19

Table of Contents

Advertisement

■Note the following points when you store a battery pack:
⿠Storage in a fully charged state (the state immediately after
charging is completed)
⿠Storage with no battery power left (the state you cannot turn
on the power of the handset due to battery drain)
These may lower the battery pack's performance and shorten its
operating life.
Before storing a battery, check its remaining battery level: it is
recommendable, as a general rule, for the battery icon to show
two bars or for its remaining battery level to be about 40%.
Notes on handling adapters and desktop holder
■Charge the battery in a place with an appropriate ambient
temperature of 5° C to 35° C.
■Charge the battery where:
⿠There is very little humidity, vibration, and dust.
⿠There are no land-line phones, television sets or radios nearby.
■While you are charging, the adapter may become warm. This is
not a malfunction, so you can keep on using.
■Do not use the DC adapter for charging the battery when the
car engine is not running.
The car battery could go flat.
■When using the power outlet having the disengaging prevention
mechanism, observe the instructions given in that instruction
manual.
■Do not give a strong shock. Also, do not deform the charging
terminal.
Malfunction may result.
■When housing the leg onto the desktop holder, be careful that
your fingers or the adapter cable not to be caught between
them.
Accidents such as injury or damage may result.
Notes on handling touch pen
■Use the touch pen only with the FOMA terminal which supports
it: Do not use it with any other terminals.
Malfunction or damage of device may result.
■The touch pen is not waterproofed. Notes that if the touch pen
gets wet, moisture may remain inside the cap.
Notes on handling the UIM
■Do not apply more force than is necessary when installing or
removing the UIM.
■The warranty does not cover damage caused by inserting the
UIM into some other types of IC card reader/writer.
■Always keep the IC portion clean.
■Use a dry soft cloth such as the one for cleaning glasses to
clean the equipment.
■It is recommended that you make separate notes of the
information stored on the UIM and keep such notes in a safe
place.
We take no responsibility for any loss of the stored data items.
■For the environmental protection, bring any unneeded UIMs to
a handling counter such as a docomo Shop.
■Do not damage, carelessly touch, or short-circuit the IC.
Data might be lost or malfunction may result.
■Do not drop the UIM or subject it to strong impacts.
Malfunction may result.
■Do not bend the UIM or place something heavy on it.
Malfunction may result.
■Into the FOMA terminal, do not insert the UIM with a label or
sticker pasted.
Malfunction may result.
17

Advertisement

Table of Contents
loading

Table of Contents