NTT docomo P-06C STYLE Series Instruction Manual page 22

Table of Contents

Advertisement

Removing/Attaching the Back Cover
■Removing the back cover
① While pushing down on the area
around the f mark in direction A,
slide the back cover (by 2 mm or more)
in direction B to disengage and remove
the cover.
② Using the projections on the inner
cover, pull up the inner cover in the
direction shown by the arrow and open
it until it will go no further.
⿠The inner cover should be firmly
closed for maintaining waterproofness.
Opening the cover forcibly may injure
your nails or fingers.
■Attaching the back cover
① Fit the claws at the left, right and bottom sides of the inner cover
into the corresponding indentations, and push the cover into place.
Rear surface of inner cover
② Push the eight ● marks printed on the
sticker of the inner cover, and ensure
that no float is found anywhere on the
cover.
20
Packing
Claw
③ With the back cover stayed open
about 2 mm, match it to the groove
on the FOMA terminal. Then while
pushing the back cover as a whole
downward, slide it in the direction of
the arrow, and then install.
④ Confirm there is no gap between the back cover and the FOMA
terminal.
Caution
■About FOMA terminal
⿠Do not wash the FOMA terminal with a washing machine or ultrasonic
cleaner.
⿠Never charge the battery when it gets wet.
⿠Do not leave the FOMA terminal with drops of water remained on.
・ The connector terminal might be short-circuited.
・ Water might enter into the inside of the FOMA terminal through
the keys or hinges. In cold districts, drops of water on the FOMA
Projection
terminal might freeze, resulting in malfunction.
If the FOMA terminal gets wet, keep the back cover attached and the
connector terminal cover closed, drain off the water (see page 21), and
immediately wipe off the moisture remaining on the FOMA terminal
with a clean dry cloth.
⿠Do not drop the FOMA terminal nor give a shock to it.
The deterioration of the waterproof performance might result
depending on the damage.
⿠Do not soak the FOMA terminal in hot water, use in a sauna, nor
expose to hot wind currents such as those of a dryer.
⿠The FOMA terminal does not float on water.
⿠Do not directly expose to the strong water flows that exceed the
standard (see page 18) or submerge the mobile phone in water.
⿠Do not directly place the FOMA terminal on sandy beaches.
・ Sands enter into the holes on the microphone, earpiece, or
speakers may reduce the volume.
・ If you operate the FOMA terminal with water drops or sands
adhered to, sound might be deteriorated.
・ Even the slightest sands entered from the connector terminal cover,
inner cover or back cover could cause water to enter the inside of
the FOMA terminal.
Approx. 2 mm

Advertisement

Table of Contents
loading

Table of Contents