European Rf Exposure Information; Fcc Notice; Fcc Rf Exposure Information; Declaration Of Conformity - NTT docomo P-06C STYLE Series Instruction Manual

Table of Contents

Advertisement

European RF Exposure Information

This mobile phone complies with the EU requirements for
exposure to radio waves.
Your mobile phone is a radio transceiver, designed and
manufactured not to exceed the SAR* limits** for exposure to
radio-frequency (RF) energy, which SAR* value, when tested for
compliance against the standard was 0.877 W/kg.
While there may be differences between the SAR* levels of
various phones and at various positions, they all meet*** the EU
requirements for RF exposure.
*
The exposure standard for mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
**
The SAR limit for mobile phones used by the public is 2.0 watts/
kilogram (W/kg) averaged over ten grams of tissue, recommended
by The Council of the European Union. The limit incorporates a
substantial margin of safety to give additional protection for the
public and to account for any variations in measurements.
*** Tests for SAR have been conducted using standard operating
positions with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the maximum
value. This is because the phone is designed to operate at multiple
power levels so as to use only the power required to reach the
network. In general, the closer you are to a base station antenna,
the lower the power output.

Declaration of Conformity

The product "P-06C" is declared to conform with the essential
requirements of European Union Directive 1999/5/EC Radio and
Telecommunications Terminal Equipment Directive 3.1(a), 3.1(b)
and 3.2. The Declaration of Conformity can be found on http://
panasonic.net/pmc/support/index.html.
※The European RTTE approval of this product is limited to the use of
the P-06C handset, Battery Pack and FOMA AC Adapter for Global
use (100 to 240 V AC) only. Other accessories are not part of the
approval.

FCC Notice

⿠This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
⿠Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.

FCC RF Exposure Information

This model phone meets the U.S. government's requirements for
exposure to radio waves.
Your wireless phone contains a radio transmitter and receiver. Your
phone is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These limits
are part of comprehensive guidelines and establish permitted levels
of RF energy for the general population. The guidelines are based on
standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate (SAR). The SAR
limit set by the FCC is 1.6 W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be well
below the maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required
to reach the network. In general, the closer you are to a wireless base
109

Advertisement

Table of Contents
loading

Table of Contents